Skip to main content
Help
Editing Step 9 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Remove the power button, door sensor, and USB cables from the circuit board.

Slide back the catch on the Ctrl Panel socket, and remove the flat-flex.

Many repairs may not require this panel to be fully removed, so these cables may be left attached, if care is taken not to damage them.

Remove the 2 screws on the front left, and the one on the front right.

Release the clips in the paper output area

Release the two clips on the underside of the printer.

Pull the front panel free.

Your contributions are licensed under the open source Creative Commons license.