Skip to main content

Changes to Step #4

Edit by Samantha Woo

Edit approved by Samantha Woo

Deleted
Added
Unchanged

Step Lines

[* icon_note] If you are trying to remove the belt, you may skip to the next step.
[* black] Remove the 0.75-in Torx #20 screw in front of the motor using a T15T20 Torx Screwdriver.
[* black] Remove the 0.75-in Torx #20 screw in front of the motor using a T15T20 Torx Screwdriver.
[* icon_note] The motor is the gray block on the right side of the floor nozzle (when the nozzle faces towards you).