Skip to main content

Changes to Step #4

Edit by Kristen Gismondi

Edit approved by Kristen Gismondi

Deleted
Added
Unchanged

Step Lines

[* icon_note] If you are trying to remove the belt, you may skip to the next step.
[* blackred] Remove the 0.75-in7.5mm Torx #20 screw in front of the motor using a T20 Torx Screwdrivermotor.
[* blackred] Remove the 0.75-in7.5mm Torx #20 screw in front of the motor using a T20 Torx Screwdrivermotor.
[* icon_note] The motor is the gray block on the right side of the floor nozzle (when the nozzle faces towards you).

Image 1

Old Version

New Version