Skip to main content

Changes to Step #4

Edit by David Ton

Edit approved by David Ton

Deleted
Added
Unchanged

Step Lines

[* black] Apply dielectric grease to the insides of two new crimp connectors.
[* black] Insert the stripped ends of the wire into the crimp connectors.
[* black] Locate the ends of the replacement power cord. These should be already stripped; if they are not, strip 2 cm from them using wire strippers.
[* black] Feed the ends of the replacement power cord into the crimp connectors. Crimp the connectors using the appropriate crimping tool.
[* black] Feed the ends of the replacement power cord into the crimp connectors. Crimp the connectors using the appropriate crimping tool.