Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #4

Edit by Alexander Prasil

Edit approved by Alexander Prasil

Before
After
Unchanged

Step Lines

[* black] Use the #00 Phillips bit to remove the (2) screws from the motherboard
[* black] Use the spudger tool to peel away the mesh tape and reveal the ribbon connectors
[* black] Use the opening tool to lift the brown and black tabs to release the ribbon cables and disconnect them
[* black] The ribbon cables should be free. Pull back on the ribbons to release them from their connectors
[* black] Slowly lift the vibration motor away from the frame and peel up the tape