Skip to main content

Changes to Step #5

Edit by Scott Havard

Edit approved by Scott Havard

Deleted
Added
Unchanged

Step Lines

[* black] While holding down the corners of the device, repeatedly pull up on the display then ease it back down to weaken the adhesive.
[* black] Once you've opened a small gap between the front panel and the rear case, insert the blade of a halberd spudger or an opening pick in the gap you've created.
[* blackicon_caution] Do not insert the pick more than 2 millimeters. Going any farther will permanently damage the display assembly. If using a halberd spudger, slice with the shortest part of the blade, as shownblade.
[* blackicon_caution] Do not insert the pick more than 2 millimeters. Going any farther will permanently damage the display assembly. If using a halberd spudger, slice with the shortest part of the blade, as shownblade.