Skip to main content

Fix Your Stuff

Right to Repair

Store

Changes to Step #17

Edit by Sam Goldheart

Edit approved by Sam Goldheart

Before
After
Unchanged

Step Lines

[* black] Two clips secure the RAM module in place, one on each side. Using your fingers, spread the clips away from the RAM module.
[* icon_note] When released, the RAM module will pop up at a slight angle.
[* black] Lift the RAM module to an angle of about 30 degrees and slide it out.
[* icon_caution] When handling the RAM module, touch only the outside edges. Take care not to touch the gold-colored contact points along the bottom edge.
[* black] To install a new RAM module, slide it in place at about the same angle until it is snug, and then swing it downward until the two clips snap into place.

Image 1

No previous image

Added