Changes to Step #2

Edit by Justin Wheeler

Edit approved by Justin Wheeler

Deleted
Added
Unchanged

Step Lines

[* green] Using your H 6.0 allen wrench, remove the four black bolts shown in the picture.
[* black] Take off the iron plate holding the wheel in place.
[* black] Remove the Motor/Wheel and set it aside close by to the hoverboard.
[* icon_caution] The wires from the Motor/Wheel should still be connected to the motherboard.
[* icon_caution] These bolts are very tight, it may be difficult to remove them. Try using a tool with a long handle.