Skip to main content

Changes to Step #3

Edit by Nick

Edit approved by Nick

Before
After
Unchanged

Step Lines

[title] Remove the rubber bumpers
-[* black] Once the drive is removed and the drive clip is unscrewed, remove the rubber bumpers from the drive. To do this, pull them off of the drive as shown. Transfer these to the new hard drive you are installing in the system.
-[* icon_note] These bumpers are held in with double sided tape. The tape will usually withstand 1-3 uses. After this you will need to either replace the tape on the drive bumpers or buy new ones.
+[* icon_reminder] These bumpers are held in with double sided tape. The tape will likely lose it's stickiness after one use, but it is not required to secure the drive bumpers.
+[* black] Once the drive is removed from the clip, remove the rubber bumpers. To do this, pull them off of the drive as shown in the guide pictures. Transfer these bumpers to your replacement drive.