Skip to main content

Changes to Step #3

Edit by Nick

Edit approved by Nick

Before
After
Unchanged

Step Lines

[title] Remove the rubber bumpers
-[* black] Once you have the clip off, you can now remove the drive's rubber bumbers. To do this, peel them off and they will come off.
-[* icon_note] These bumpers are held in with double sided tape. The tape will usually withstand 1-3 reuses, but after this you will need to either replace tape in the drive bumpers or buy new ones.
+[* black] Once the drive is removed and the drive clip is unscrewed, remove the rubber bumpers from the drive. To do this, pull them off of the drive as shown. Transfer these to the new hard drive you are installing in the system.
+[* icon_note] These bumpers are held in with double sided tape. The tape will usually withstand 1-3 uses. After this you will need to either replace the tape on the drive bumpers or buy new ones.