Skip to main content

Changes to Step #2

Edit by Nick

Edit approved by Nick

Before
After
Unchanged

Step Lines

[title] Remove the drive clip
[* black] To remove the drive clip, remove the one screw from the left side that holds the drive in. Use a ***Phillips #0*** bit for this step.
[* black] Once the screw is removed, pull the clip off from the left side of the drive clip.
[* icon_note] The right side of the clip is used for drive alignment. Because of this, there is no screw on the right side of the drive clip.
+[* icon_reminder] If you are using this guide to remove the hard drive to install into another Dell computer that uses the same clip or removing it before sending the system to Depot, these steps are not required.