Skip to main content

Changes to Step #2

Edit by Nick

Edit approved by Nick

Before
After
Unchanged

Step Lines

[title] Remove the drive clip
-[* black] To remove the drive clip, remove the one screw from the left side that holds the drive in. To remove the clip, pull it off from this side and it will come lose.
-[* icon_note] The other side of the clip is held in with a pin for alignment, so you do not have to worry about getting this wrong when reassembling the system. This pin is marked in orange.
+[* black] To remove the drive clip, remove the one screw from the left side that holds the drive in. Use a ***Phillips #0*** bit for this step.
+[* black] Once the screw is removed, pull the clip off from the left side of the drive clip.
+[* icon_note] The right side of the clip is used for drive alignment. Because of this, there is no screw on the right side of the drive clip.