Skip to main content

Changes to Step #1

Edit by Nick

Edit approved by Nick

Before
After
Unchanged

Step Lines

[title] Remove the chassis screws
[* black] To remove the hard drive from the computer, remove the two screws holding it in. Use the ***Phillips #1*** bit to do this.
-[* icon_caution] The second screw, marked in orange is directly screwed into the chassis. DO NOT tighten this very far when reassembling, as the clip will break here. It isn't the end of the world if this happens, but you will need to replace it to ensure the hard drive doesn't fall out, should you lose the other screw.
+[* icon_caution] The second screw, marked in orange is directly screwed into the chassis. DO NOT overtighten this screw. If you do this, the clip will break in this area and you will need to replace it, since there are only 2 screws that hold the hard drive in.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added