Changes to this Step
Edit by Jake Devincenzi —
- Before
- After
- Unchanged
Step Lines
| - | [* black] Set the new hard drive into the open area where the plastic positioner was. |
|---|---|
| - | [* icon_note] Make sure that the connectors on the hard drive are facing down, as shown, otherwise you will not be able to install the drive. |
| - | [* black] While firmly holding the enclosure in place with one hand, use your other hard to press the hard drive over the enclosure connectors. |
| - | [* black] Once the hard drive is snug, reinsert the plastic positioner, while holding the hard drive against the bottom of the enclosure. |
| + | [* red] Make sure that the hard drive connectors are facing down before placing it into the enclosure. |
| + | [* black] Gently place the hard drive into the enclosure's hard drive slot. |
| + | [* black] While firmly holding the enclosure in place with one hand, use your other hard to press the hard drive into the enclosure connectors. |
Image 1
Old Version
New Version
Image 2
Old Version
New Version
Image 3
Old Version
New Version