Skip to main content

Changes to Step #4

Edit by Dominik Schnabelrauch

Edit approved by Dominik Schnabelrauch

Before
After
Unchanged

Step Lines

[title] saddle montage
-[* black] use assembly paste on saddle
-[* black] put in saddle tube and pull the wire in the lower frame end
-[* black] tighten saddle
+[* black] Attaching the saddle to the frame is a pice of cake. Take the saddle and apply assembly paste to the bottom part of the seat post, around the clamping area of it and inside the seat tube.
+[* black] Slide the saddle into the seat tube while pulling out the seat post cable in the lower end of the seat tube.
+ [* icon_caution] Note the minimum and maximum height markings on the seat post.
+ [* black] Tighten the bolt of the clamp with the torque wrench and you're good.