Skip to main content

Changes to Step #3

Edit by Dominik Schnabelrauch

Edit approved by Dominik Schnabelrauch

Before
After
Unchanged

Step Lines

-[title] Bar montage
[* black] Go on with positioning the handlebar centered in the stem clamp and put the faceplate back on.
[* black] Retighten the bolts of the faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar.
[* black] Now tighten the bolts in a cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around ***8 Nm***.
[* icon_caution] Make sure the upper and lower gaps between faceplate and stem body are parallel and with an identical width.