Skip to main content

Changes to Step #6

Edit by Sam Goldheart

Edit approved by Sam Goldheart

Before
After
Unchanged

Step Lines

-[* black] We jettison four more screws and yet the band covering the LED array is still stuck down with two rows of adhesive pads. No heat required, just prying, as the adhesive is mild-to-medium flavored.
-[* black] One pop connector services this whole array of LEDs. Mild adhesive secures the LED array to the controller chassis.
+[* black] A few more screws later, the [http://starwars.wikia.com/wiki/Outer_Rim_territories|outer rim|new_window=true] of the loop is still attached by a bunch of glue, there's no recourse but to pry pry again.
+ [* black] No heat required, just prying, as the adhesive is mild-to-medium flavored.
+[* black] Uncovered, the single-cable LED array peels off fairly easily, after being disconnected.
+[* black] All 22 IR LEDs are conveniently labeled, and there's even a barcode. Cross your fingers for Oculus-provided replacement parts!