Skip to main content

Changes to Step #4

Edit by Michael Sweany

Edit declined by Reed Danis

Deleted
Added
Unchanged

Step Lines

[* icon_note] Prepare your component for soldering by removing any excess solder from the contacts. The contacts should be clean enough to pass through the solder pad holes.
[* black] Run the soldering iron tip down the lengths of each contact to wipe the solder away from the component. Clean the iron's tip between strokes by wiping it against a moist sponge.
[* icon_caution] Excessive heat will damage'''WILL DAMAGE''' the components, so do not apply the soldering iron to the component for long amounts of timetoo long.
[* icon_caution] Excessive heat will damage'''WILL DAMAGE''' the components, so do not apply the soldering iron to the component for long amounts of timetoo long.