Skip to main content

Changes to Step #4

Edit by Miroslav Djuric

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] Next, prepareicon_note] Prepare your component for soldering by removing any excess solder from the contacts. TheThe contacts should be clean enough to pass through the holes you just opened without interferencesolder pad holes.
[* icon_note] To cleanblack] Run the contacts of a component, run the tip of a soldering iron tip down the lengthlengths of theeach contact to wipe the solder away from the component. Clean the iron's tip between strokes by wiping it against a moist sponge.
[* icon_caution] DoExcessive heat will damage the components, so do not overheatapply the component while preppingsoldering iron to the contactscomponent for long amounts of time.
[* black] Next, prepareicon_note] Prepare your component for soldering by removing any excess solder from the contacts. TheThe contacts should be clean enough to pass through the holes you just opened without interferencesolder pad holes.
[* icon_note] To cleanblack] Run the contacts of a component, run the tip of a soldering iron tip down the lengthlengths of theeach contact to wipe the solder away from the component. Clean the iron's tip between strokes by wiping it against a moist sponge.
[* icon_caution] DoExcessive heat will damage the components, so do not overheatapply the component while preppingsoldering iron to the contactscomponent for long amounts of time.