Skip to main content

Changes to Step #14

Edit by Miroslav Djuric

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] To solder the new leads to the board, place the bare end of one lead onto the bead of solder on its corresponding solder pad.
[* black] Press the tip of the soldering iron onto the solder bead until it melts.
[* black] Slide the exposed end of the lead into the liquid solder until it is in the center of the bead, then remove the soldering iron.
[* black] Continue with the other two connections the same way, taking special care not to solder two of the pads together.
[* black] Continue with the other two connections the same way, taking special care not to solder two of the pads together.