Skip to main content

Changes to Step #13

Edit by Walter Galan

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] Insert wisdom hereicon_note] The solder bead should look like a small dome or hemisphere. If it is flat or jagged, simply place the soldering iron back on the solder to re-melt it and then pull the soldering iron away. It may require a little more solder if this does not work.
[* black] Insert wisdom hereicon_note] The solder bead should look like a small dome or hemisphere. If it is flat or jagged, simply place the soldering iron back on the solder to re-melt it and then pull the soldering iron away. It may require a little more solder if this does not work.

Image 1

No previous image

Added