Skip to main content

Changes to Step #2

Edit by Michael Sweany

Edit declined by Reed Danis

Deleted
Added
Unchanged

Step Lines

[* blackred] To open the hole blocked by solder, heat the solder pad with the tip of a soldering iron. Push through the molten solder from the other side with a staple or sewing needle.
[* icon_note] In our case, we decided to use a right angle pick. Leadblack] Push through the molten solder will not stick to steel, so pretty much any thin steel can be usedfrom the other side using a sewing needle or something similar.
[* icon_cautionicon_note] Pushing the tool all the way through the hole may require heating the pad several times. As a rule of thumb, heat the solder just enough for it to melt, then remove the soldering tip from the pad. Excessive heat
[* icon_caution] EXCESSIVE HEAT
will damage electronic components.
[* blackred] To open the hole blocked by solder, heat the solder pad with the tip of a soldering iron. Push through the molten solder from the other side with a staple or sewing needle.
[* icon_note] In our case, we decided to use a right angle pick. Leadblack] Push through the molten solder will not stick to steel, so pretty much any thin steel can be usedfrom the other side using a sewing needle or something similar.
[* icon_cautionicon_note] Pushing the tool all the way through the hole may require heating the pad several times. As a rule of thumb, heat the solder just enough for it to melt, then remove the soldering tip from the pad. Excessive heat
[* icon_caution] EXCESSIVE HEAT
will damage electronic components.

Image 1

Old Version

New Version