Skip to main content

Changes to Step #2

Edit by Andrew Bookholt

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] Insert wisdom hereTo open the hole blocked by solder, heat the solder pad with the tip of a soldering iron while pushing through the molten solder from the other side of the hole with a thin steel rod.
[* black] Do not overheat the the solder pad. As a rule of thumb, heat the solder just enough for it to melt, then remove the tip of the soldering iron from the joint.
[* icon_note] In our case, we decided to use a right angle pick. Some other possible tools for this process include straightened out staples or thin sewing needles. Lead solder will not stick to steel
.
[* black] Insert wisdom hereTo open the hole blocked by solder, heat the solder pad with the tip of a soldering iron while pushing through the molten solder from the other side of the hole with a thin steel rod.
[* black] Do not overheat the the solder pad. As a rule of thumb, heat the solder just enough for it to melt, then remove the tip of the soldering iron from the joint.
[* icon_note] In our case, we decided to use a right angle pick. Some other possible tools for this process include straightened out staples or thin sewing needles. Lead solder will not stick to steel
.

Image 2

Old Version

New Version