Skip to main content

Changes to Step #1

Edit by Kyle Wiens

Edit approved by Kyle Wiens


Step Lines

[* icon_notetitle] Beginning Guide
[* icon_notetitle] Beginning Guide
[* icon_note] To start, let's solder a large component held to a circuit board with [link||thru-hole] solder pads.
[* black] A capacitor was already removed from the two solder pads. Each pad was heated while the capacitor was pulled away from the board.
[* icon_reminder] Notice how the solder holes are completely covered with solder. Opening these holes -- so the capacitor lead can be pushed through -- will greatly simplify installation.