Skip to main content

Changes to Step #1

Edit by Miroslav Djuric

Pending approval

Deleted
Added
Unchanged

Step Lines

[* icon_note] To start, we will show you how tolet's solder a large component held to a circuit board with holes through[link|http://en.wikipedia.org/wiki/Through-hole|thru-hole] solder pads.
[* black] In this particular case, we will replace a badA capacitor on a circuit board. The picture on the left showswas already removed from the two solder pads after the capacitorpads. Each pad was removed by heating each of the padsheated while pulling the capacitor was pulled away from the board.
[* icon_reminder] Notice how the right solder hole isholes are completely covered with solder. Opening this holethese holes -- to the capacitor lead can be pushed through -- will greatly simplify installation.
[* icon_note] To start, we will show you how tolet's solder a large component held to a circuit board with holes through[link|http://en.wikipedia.org/wiki/Through-hole|thru-hole] solder pads.
[* black] In this particular case, we will replace a badA capacitor on a circuit board. The picture on the left showswas already removed from the two solder pads after the capacitorpads. Each pad was removed by heating each of the padsheated while pulling the capacitor was pulled away from the board.
[* icon_reminder] Notice how the right solder hole isholes are completely covered with solder. Opening this holethese holes -- to the capacitor lead can be pushed through -- will greatly simplify installation.