Skip to main content

Changes to Step #1

Edit by Walter Galan

Pending approval

Deleted
Added
Unchanged

Step Lines

[* icon_note] In this guide, we will teach you how to solder three types of connections commonly seen in electronic gadgets. To start, we will show you how to solder a large component held to a circuit board with holes through solder pads.
[* black] In this particular case, we will replace a bad capacitor on a circuit board. The picture on the left shows the two solder pads after the capacitor was removed by heating each of the pads while pulling the capacitor away from the board.
[* icon_noteicon_reminder] Notice how the right solder hole is completely covered with solder. Opening this hole will greatly simplify installation.
[* icon_noteicon_reminder] Notice how the right solder hole is completely covered with solder. Opening this hole will greatly simplify installation.