Skip to main content

Changes to Step #3

Edit by Chase Mamatey

Edit approved by Chase Mamatey

Before
After
Unchanged

Step Lines

[* black] Lift the camera body out of the plastic frame by using two small plastic opening tools as follows:
[* red] Place one opening tool directly under the base of the camera ribbon cable and camera body, applying upward pressure.
[* orange] At the same time, use the other tool to release one of the clips on the left or the right of the camera body.
[* icon_note] The left side of the camera body is shown here as the top, with the right side shown as the bottom.
+ [* icon_caution] Be careful not to bend the retaining clips too far as this can damage them.