Skip to main content

Changes to Step #3

Edit by Kristen Gismondi

Edit approved by Kristen Gismondi

Before
After
Unchanged

Step Lines

[* black] Lift the camera body out of the plastic frame by using two small plastic opening tools as follows:
-[* red] Place one opening tool directly under the base of the camera ribbon cable and camera body, applying upward pressure.
-[* orange] At the same time, use the other tool to release one of the clips on the left or the right of the camera body.
+[* black] Place one opening tool directly under the base of the camera ribbon cable and camera body, applying upward pressure.
+[* black] At the same time, use the other tool to release one of the clips on the left or the right of the camera body.
[* icon_note] The left side of the camera body is shown here as the top, with the right side shown as the bottom.
[* icon_caution] Be careful not to bend the retaining clips too far as this can damage them.

Image 1

Old Version

New Version