Skip to main content

Changes to Step #1

Edit by Yang Zhao

Edit approved by Yang Zhao

Deleted
Added
Unchanged

Step Lines

[title] Open the UAP-AC-LITE
[* red] The front cover is secured by 5 tabs. Moderate pressure from a prying tool close to the tabs will work them loose.
[* black] Insert the Jimmy in the space between two clips where it is easiest. The blade must be worked past the lip and a fair ways towards the center of the front cover before enough leverage can be gained.
[* black] Once the Jimmy is in, work it towards
near a clip, and create a big enough gap to insert a prying tool. Moderate pressure should force the clips open.
[* black] The first clip isThere are a number of alignment tabs that can get in the hardest. Itway. It is recommendedbest to start prying attry and work the 2-o'clock position,Jimmy towards the clip at 1-o'clockcenter of the front cover, hugging its inside surface.
[* red] The front cover is secured by 5 tabs. Moderate pressure from a prying tool close to the tabs will work them loose.
[* black] Insert the Jimmy in the space between two clips where it is easiest. The blade must be worked past the lip and a fair ways towards the center of the front cover before enough leverage can be gained.
[* black] Once the Jimmy is in, work it towards
near a clip, and create a big enough gap to insert a prying tool. Moderate pressure should force the clips open.
[* black] The first clip isThere are a number of alignment tabs that can get in the hardest. Itway. It is recommendedbest to start prying attry and work the 2-o'clock position,Jimmy towards the clip at 1-o'clockcenter of the front cover, hugging its inside surface.
[* black] The PCB is held down by 3 screws. It is not necessary to remove the board for this repair.

Image 2

Old Version

New Version

Image 3

No previous image

Added