Skip to main content

Changes to Step #1

Edit by Keaton Frahmann

Edit approved by Keaton Frahmann

Before
After
Unchanged

Step Lines

+[* black] Remove the external connector from its housing by lifting it up, then out.
+[* black] Next lift the internal power supply brick out of the device.
+ [* icon_note] You may have to wiggle the brick slightly when removing it, but it will lift straight up and out as nothing else is holding it down.
+[* red] Disconnect the SATA connector from the hard drive. This cable does not have a locking mechanism so it can just be pulled out.
+[* yellow] Disconnect the final power cable from the logic board and be careful to push in the tab on the logic board connector to release the cable lock.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added