Skip to main content

Changes to Step #1

Edit by Keaton Frahmann

Edit approved by Keaton Frahmann

Before
After
Unchanged

Step Lines

[* black] Remove the external connector from its housing by lifting it up, then out. Found next to the ethernet ports.
[* black] Next lift the internal power supply brick out of the device.
[* icon_note] You may have to wiggle the brick slightly when removing it, but it will lift straight up and out as nothing else is holding it down.
[* red] Disconnect the SATA connector from the hard drive. This cable does not have a locking mechanism so it can just be pulled out.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added