Skip to main content

Changes to Step #1

Edit by JR Alfano

Edit approved by JR Alfano


Step Lines

[* black] Remove the external connector from its housing by lifting it up, then out.
[* black] Lift the internal power supply brick out of the device.
[* icon_note] You may have to wiggle the brick slightly when removing it, but it will lift straight up and out as nothing else is holding it down.
[* red] Disconnect the SATA connector from the hard drive. This cable does not have a locking mechanism so it can just be pulled out.
[* black] Disconnect the final power cable from the logic board.
[* icon_note] Be careful when pushing in the tab on the logic board connector to release the cable lock.

Image 2

Old Version

New Version

Image 3