Skip to main content

Changes to this Step

Edit by Keaton Frahmann

Edit approved by Keaton Frahmann

Before
After
Unchanged

Step Lines

[* black] Turn the device upside down to reveal the rubber section of the back plate. Using a metal spudger carefully wedge the blunt tip into the space between the aluminum back plate and the rubber and separate the two pieces.
[* black [* icon_note] This may take a few minutes to pry the rubber completely off and once you are able to get a good grip on the rubber it is easier to start peeling it off with your hands instead.
[* black [* icon_note] This may take a few minutes to pry the rubber completely off and once you are able to get a good grip on the rubber it is easier to start peeling it off with your hands instead.
[* icon_note] Don't worry about putting the rubber back on, the adhesive has plenty of strength to refix itself to the aluminum when you are done.