Skip to main content

Changes to Step #3

Edit by Eric H

Edit declined by Walter Galan

Deleted
Added
Unchanged

Step Lines

[* black] Use a plastic opening tool to pull the pressure contact from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of the small black ground clip on the upper screw of the battery connector.
[*
black] Be '''VERY''' careful not to remove the pressure contactbattery connection point from the logic board. There are 4 very small soldering points awaiting this mistake!
[* icon_caution] Take notice of the small black ground clip on the upper screw of the battery connector.
[*
black] Be '''VERY''' careful not to remove the pressure contactbattery connection point from the logic board. There are 4 very small soldering points awaiting this mistake!