Skip to main content

Fix Your Stuff

Right to Repair


Changes to Step #3

Edit by Rob Hendricks

Edit approved by Jake Devincenzi


Step Lines

[* black] Use a plastic opening tool to pull the pressure contact from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of the small black ground clip on the upper screw of the battery connector.
[* black] Be '''VERY''' careful not to remove the pressure contact point from the logic board