Changes to Step #1
Edit by Rick Marshall —
Edit approved by Jake Devincenzi
- Before
- After
- Unchanged
Step Lines
[* black] Remove the following screws securing the battery connector to the logic board: | |
[* red] One 1.7 mm Phillips screw | |
- | [* orange] One 1.5 mm Phillips screw |
+ | [* orange] One 1.5 mm Phillips screw. Pay attention to the small grounding clip (visible if you magnify the first image). |
[* black] Use a plastic opening tool to gently detach the battery connector from the device. |