Skip to main content

Changes to Step #10

Edit by Andrew Optimus Goldheart

Edit approved by Andrew Optimus Goldheart

Before
After
Unchanged

Step Lines

[* black] Tighten the outer two screws along the inner edge of the trackpad and check the alignment of it on the outer side of the upper case.
-[* black] If its alignment looks good, install the rest of the Y0 Tri-wing screws along the inner edge of the trackpad.
+[* black] If its alignment looks good, install the rest of the Tri-point screws along the inner edge of the trackpad.
[* black] Before reassembling your machine, verify that the set screw is still installed in a position so the mouse will click correctly.