Skip to main content

Changes to Step #4

Edit by Mackenzie Keane

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] The inverter board is the smaller board in the corner.
[* red] Remove the three 7.69 mm PhillipPhillips #2 screws from the inverter board.
[* orange] Remove the two 7.69 mm PhillipPhillips #2 grounding screws from the wire with the black connector.
[* red] Remove the three 7.69 mm PhillipPhillips #2 screws from the inverter board.
[* orange] Remove the two 7.69 mm PhillipPhillips #2 grounding screws from the wire with the black connector.
[* icon_note] Gently pull the inverter board away from the case. Note that the board is still connected to several components by wires.