Skip to main content

Changes to Step #4

Edit by Phil Jones

Pending approval

Deleted
Added
Unchanged

Step Lines

[* black] The inverter board is the smaller board in the corner.
[* red] Remove the three 7.69 mm Phillip #2 screws from the inverter board.
[* orange] Remove the two 7.69 mm Phillip #2 grounding screws from the wire with the black connector.
[* blackicon_note] Gently pull the inverter board away from the case.
[* icon_note]
Note that the board is still connected to several components by wires.
[* blackicon_note] Gently pull the inverter board away from the case.
[* icon_note]
Note that the board is still connected to several components by wires.