Skip to main content

Changes to Step #4

Edit by Mackenzie Keane

Pending approval

Deleted
Added
Unchanged

Step Lines

[* red] Using a Phillips #2 Screwdriver, remove theRemove the three 7.69 mm Phillip #2 screws from the inverter board.
[* black] Remove the two 7.69 mm Phillip #2 screws from the wire with the black connector.
[* red] Using a Phillips #2 Screwdriver, remove theRemove the three 7.69 mm Phillip #2 screws from the inverter board.
[* black] Remove the two 7.69 mm Phillip #2 screws from the wire with the black connector.
[* black] Gently pull the inverter board away from the case.
[* icon_note] Note that the board is still connected to several components by wires.