Skip to main content

Changes to Step #4

Edit by Charley Grove

Pending approval

Deleted
Added
Unchanged

Step Lines

[* red] Using a Phillips #2 Screwdriver, remove the screws from the inverter board and the two screws holding the wire in place.
[* icon_note] Gentlyblack] Gently pull the inverter board away from the case. Note
[* icon_note] Note
that the board is still connected to several components by wires.
[* icon_note] Gentlyblack] Gently pull the inverter board away from the case. Note
[* icon_note] Note
that the board is still connected to several components by wires.