Skip to main content

Changes to Step #3

Edit by Evan Noronha

Edit approved by Evan Noronha

Deleted
Added
Unchanged

Step Lines

[* black] Pull up on the suction cup to create a small gap between the display assembly and the rear case.
[* black] Insert the flat end of a spudger into the gap.
[* icon_note] The watertight adhesive holding the display in place is very strong, and creating this initial gap takes a significant amount of force. If you're having a hard time opening a gap, rock the screen up and down to weaken the adhesive until you can fit a spudger inside.