Skip to main content

Changes to Step #7

Edit by Phillip Takahashi

Pending approval


Step Lines

[* black] Pull the vehicle speed sensor out of it's hole.
[* icon_note] Be careful to not bump too many parts while removing the sensor, as you may knock debris into the transmission which can cause premature wear or failure.
[* icon_caution] To avoid the risk of damaging the wiring harness, do not pull the sensor by its wires.
[* black] Disconnect the sensor from the wiring harness by pressing the grey tab on top of the harness connector and pulling the connector and sensor away from each other.
[* black] Remove the sensor from the engine bay.
[* icon_note] When installing the new vehicle speed sensor, be careful not to knock debris into the transmission, as the area around its hole is likely very dirty.