Skip to main content

Changes to Step #3

Edit by Navy Vet 2015

Edit approved by Navy Vet 2015

Deleted
Added
Unchanged

Step Lines

[* black] Use a Phillips head screw driver to remove the two larger screws highlighted in red.
[* black] The two smaller screws (red) were a little tricky. They are screwed down very tight. I started with a #0 phillips head and slightly stripped the screw head. Not enough to destroy it. I recommend using a #1 phillips head on these. I also used a small rubber grip in order to get a better grip on my screwdriver. Made it much easier.
[* black] Once screws are removed lift the plastic frame from the left side and remove it from the top of the power brick and flip it over.
[* black] NOTE:
The two screws highlighted in orange serve no purpose. There was nothing under there. Unless you have a different variation than mine there is no need to remove these screws.
[* black] Once screws are removed lift the plastic frame from the left side and remove it from the top of the power brick and flip it over.
[* black] NOTE:
The two screws highlighted in orange serve no purpose. There was nothing under there. Unless you have a different variation than mine there is no need to remove these screws.