Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Changes to Step #6

Edit by Ben Eisenman

Pending approval

Before
After
Unchanged

Step Lines

[* icon_note] Do not yank the upper case off quickly. The case is attached to the logic board via a ribbon cable.
[* black] Lift up at the rear of the case and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case.
[* black] '''Warning: ThereThere are 4four plastic clips above the DVD slot, and another above and to the left of the IR sensor. These clips can be very difficult to disengage without prying. They can also be difficult to re-engage during reassembly.'''
[* black] This can be one of the most challenging steps to perform without marring the finish. For more information, refer to the notes associated with this step
reassembly.
[* black] '''Warning: ThereThere are 4four plastic clips above the DVD slot, and another above and to the left of the IR sensor. These clips can be very difficult to disengage without prying. They can also be difficult to re-engage during reassembly.'''
[* black] This can be one of the most challenging steps to perform without marring the finish. For more information, refer to the notes associated with this step
reassembly.