Skip to main content

Changes to Step #2

Edit by mayer

Pending approval


Step Lines

[* icon_note] Support the display with one hand as you remove the remaining T8 screws.
-[* red] Remove the two T8 Torx screws from each side of the display (four screws total).
+[* red] Remove the upper two full thread 10 mm T8 Torx screws from each side of the display, then the two lower shanked 13 mm screws (four screws total).
[* icon_reminder] When replacing the display, make sure that the correct screw pins down the ground loop from the display data cable.
[* black] Disconnect the two antenna cables from the airport/bluetooth card (shown in yellow circles), as well as the display cable (wide connector right hand upper corner) and the cable on top left corner of the logic board.