Skip to main content

Changes to Step #1

Edit by Jake Devincenzi

Pending approval

Deleted
Added
Unchanged

Step Lines

[* icon_note] Since the jacking location on the Accord isn't large enough to fit both a jack and a jack stand, you must raise the car by placing the jack on the front subframe.
[* black] Place a jack on the round portion of the front subframe on the driver side of the car, just inside the wheel and just outside of the front sway bar bushing.
[* black] Raise the car until you have enough room to work comfortably underneath it.
[* black] Place a jack stand under the front jacking location, the reinforced metal part of the vertical crossbeam, and lower the car onto the jack stand. Remove the jack from under the car.
[* black] Place a jack stand under the front jacking location, the reinforced metal part of the vertical crossbeam, and lower the car onto the jack stand. Remove the jack from under the car.
[* icon_caution] '''Never''' work under a car that is only supported by a jack. The jack may slip or fail, resulting in serious injury or death.