Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Changes to Step #1

Edit by jonathanmorgan

Edit approved by Walter Galan

Deleted
Added
Unchanged

Step Lines

[* black] Remove the following screws securing the antenna plate to the mini:
[* red] Two 6.6 mm T8 Torx screws
[* orange] Two 5.0 mm T8 Torx or 2.0 mm Hex screws (either screwdriver will work)
[* black] When putting back together:
[* black] it can be difficult to get the hard drive seated correctly such that the antenna plate fits in place correctly. Make sure that the hard drive is close to the power supply on the right, and just a bit behind the lip of the housing for the second hard drive, beneath it, not tight against it or on top of it. It should be able to move a bit.
[* black] Then, seat the antenna plate, attach the antenna plate to the hard drive (red screws), then lock the antenna plate into place (it has a small lip that latches over the case at the back) and screw in the orange screws.