Skip to main content

Changes to Step #31

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Deleted
Added
Unchanged

Step Lines

[* black] Remove the battery isolation pick.
[* black] Insert a plastic card underneath the logic board at the battery connector.
[* [* icon_caution] As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in [guide|63740|Step 60|stepid=134002]. Position the card exactly as shown.
[*
black] Slide the card all the way underneath the logic board, being sure to not slice intoseparating the upper button assembly cable at the edge ofadhesive along the iPadouter edge.
[* [* icon_caution] As you push through the adhesive at the outer edge of the logic board, be careful not to damage the upper button assembly ribbon cable that you disconnected in [guide|63740|Step 60|stepid=134002]. Position the card exactly as shown.
[*
black] Slide the card all the way underneath the logic board, being sure to not slice intoseparating the upper button assembly cable at the edge ofadhesive along the iPadouter edge.