Skip to main content

Changes to Step #28

Edit by Jeff Suovanen

Edit approved by Jeff Suovanen

Deleted
Added
Unchanged

Step Lines

[* black] Insert an opening pick underneathicon_caution] As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to break upsee if the adhesive holdingis softened. If not, reheat the iOpener and reapply it in placeto the back of the rear case.
[* black] Carefully insert an opening pick under the logic board, between the front-facing camera and the battery
.
[* black] Insert an opening pick underneathicon_caution] As you complete the next few steps, prying adhesive securing the logic board in place, always start by testing gently to break upsee if the adhesive holdingis softened. If not, reheat the iOpener and reapply it in placeto the back of the rear case.
[* black] Carefully insert an opening pick under the logic board, between the front-facing camera and the battery
.
[* icon_note] Be sure to insert the pick ''over'' the the antenna cable that runs along the length of the battery.
[* black] Slide the guitar pick toward the front-facing camera connector, and stop at the bend in the logic board.